Welcome to ISAserver.org

Clustered Exchange BE and FE Isa 2004 Config

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [ISA Server 2004 Firewall] >> General >> Clustered Exchange BE and FE Isa 2004 Config

Page: [1]

Message

<< Older Topic Newer Topic >>

Clustered Exchange BE and FE Isa 2004 Config - 27.Jul.2004 11:39:00 PM

isa04

Posts: 3
Joined: 27.Jul.2004
Status: offline

I am running an ISA 2004 server with a Frontend Backend (Clustered) Configuration. Everything is Server 2003. Does anyone have any documentation on this? I read the article on this website "Step-by-Step: Publishing a Single Exchange 2003 OWA with ISA 2004 Firewall Forms Based Authentication" Everything went fine after reading this. However, how do I configure this when the backend is clustered? Also, does anyone know where I can get the Isa2004 Exchange 2003 Deployment Kit?

Thanks in advance,

Post #: 1

Featured Links*

RE: Clustered Exchange BE and FE Isa 2004 Config - 28.Jul.2004 12:09:00 AM

tshinder

Posts: 47663
Joined: 10.Jan.2001
From: Texas
Status: offline

Hi isa04,

Check out:

www.msfirewall.org/isa2004kits.htm

HTH,
Tom

(in reply to isa04)

Post #: 2

RE: Clustered Exchange BE and FE Isa 2004 Config - 28.Jul.2004 3:21:00 PM

isa04

Posts: 3
Joined: 27.Jul.2004
Status: offline

Thank you for the response. I found the kit yesterday. However, how do I go about configuring this for a Clustered Backend Exchange Server 2003 setup?
Thanks in advance,

(in reply to isa04)

Post #: 3

RE: Clustered Exchange BE and FE Isa 2004 Config - 3.Aug.2004 2:27:00 PM

tshinder

Posts: 47663
Joined: 10.Jan.2001
From: Texas
Status: offline

Hi ISA,

Is this a NLB cluster?

Thanks!
Tom

(in reply to isa04)

Post #: 4

RE: Clustered Exchange BE and FE Isa 2004 Config - 4.Aug.2004 3:46:00 PM

isa04

Posts: 3
Joined: 27.Jul.2004
Status: offline

Tom,
This is not a NLB cluster.
It is a 2 node cluster with two Perc 3DC cards on two Poweredge 4600's(backend)attached to a Powervault 200S(Quorom);configured with the frontend and OWA. This configuration is working without the ISA server in place, and is failing over. Also, I have an existing checkpoint firewall and I wish to incorporate ISA behind the checkpoint to incorporate a more secure OWA environment? Do you have a solution for this.
Thanks

(in reply to isa04)

Post #: 5

RE: Clustered Exchange BE and FE Isa 2004 Config - 5.Aug.2004 2:18:00 PM

tshinder

Posts: 47663
Joined: 10.Jan.2001
From: Texas
Status: offline

Hi ISA,

Not sure how the ISA firewall would interfere with a disk cluster. Is the ISA firewall forwarding incoming connections to one IP address? I admit, I know a lot more about NLB than disk clustering [Smile]