Welcome to ISAserver.org

ISA + Symantec Enpoint Protection Manager

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [ISA Server 2004 General ] >> ISA 2004 SBS >> ISA + Symantec Enpoint Protection Manager

Page: [1]

Message

<< Older Topic Newer Topic >>

ISA + Symantec Enpoint Protection Manager - 28.May2008 8:33:43 PM

mrnato

Posts: 1
Joined: 28.May2008
Status: offline

Hi, wondering if I can get some help solving an issue...

The issue is a SEP client cannot connect with the server containing SEPM because of ISA.

I have been in contact with Symantec over this and they seem as stumped as me and keep telling me I need to exclude the server that hosts SEPM from ISA. ISA is on the same server as SEPM so this makes little sense to me.

I have made rules to allow the ports they say are needed and there seems to be a rule to allow all internal traffic anyhow.

The problem I am having is the client pc goes to connect to secreg/secreg?l=2 but in the ISA logs it says its anonymous user and the connection is denied, but another link to test connectivity to secars works fine. Both these "sites" have the same settings in IIS. I'm hoping this is just a rule or something set wrong as Symantec seem to be unhelpful on the problem.

Post #: 1

Featured Links*

RE: ISA + Symantec Enpoint Protection Manager - 2.Jul.2008 1:22:24 PM

t4djmr

Posts: 1
Joined: 2.Jul.2008
Status: offline

I recently experience a problem with SEPP. I had followed Symantec's "Best Practices" guide for SBS but no workstations could connect. The solution was to install SEPP to a "custom" web site and then remove SEP on the workstations and push out a new install package to the workstations with proper port connections. I did all this remotely without having to visit each workstation.

(in reply to mrnato)

Post #: 2