Welcome to ISAserver.org

Confused on where the SAN cert goes?

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [Forefront Unified Access Gateway 2010] >> General >> Confused on where the SAN cert goes?

Page: [1]

Message

<< Older Topic Newer Topic >>

Confused on where the SAN cert goes? - 6.May2011 12:10:55 AM

cajuntank

Posts: 3
Joined: 30.Dec.2009
Status: offline

Ok, so here's my question. I will be implementing a pair of Barracuda hardware load balancers (HLB) for client access to a pair of Exchange 2010 multirole installed servers. Normally, I would generate a certificate request for a SAN cert from my HLB and use DigiCert to fullfill the request and place the SAN cert on the HLB solution. So now lets introduce a UAG to publish that OWA, Activesync, etc... to the outside world, so now, who generates the cert request and where does is get placed?

I would really like to not get a certificate page error for my users who are on the inside of my network by using a private internal CA, but I also need to make sure my external users utilize a trusted public CA.

Thanks.

Post #: 1

Featured Links*

RE: Confused on where the SAN cert goes? - 11.May2011 6:43:35 PM

cajuntank

Posts: 3
Joined: 30.Dec.2009
Status: offline

Whew, this must be a tough one... not even a nibble?

(in reply to cajuntank)

Post #: 2

RE: Confused on where the SAN cert goes? - 29.May2011 11:47:07 PM

cajuntank

Posts: 3
Joined: 30.Dec.2009
Status: offline

Guess I'm so new to this product and never had much dealings with the ISA/TMG product that it took me a while to figure this out. I see that all I do is import the certificate and certificate chain into the UAG's certificate store from my HLB. And if I'm doing a public certificate, probably won't even have to do that since it's already trusted.

(in reply to cajuntank)

Post #: 3