Welcome to ISAserver.org

DHCP on L2 DMZ

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [Threat Management Gateway (TMG) 2010] >> General >> DHCP on L2 DMZ

Page: [1]

Message

<< Older Topic Newer Topic >>

DHCP on L2 DMZ - 6.Jul.2012 8:17:06 AM

adoner

Posts: 3
Joined: 13.Feb.2009
Status: offline

Hey. I am trying to configure a DHCP relay on a L2 segment that is only routable through the TMG. I have 3 interfaces (outside, inside (DHCP here), and dmz). I setup the routing and remote access according to the other articles on this site. However, when I start the routing service, it gets addresses on the internal scope, not the scope I setup for the DMZ. The relay is setup correctly because I see it listening for DHCP. However the routing and remote access did not get the addresses for that segment. Any ideas?