From: Recife, PE, Brazil
I had created this DWORD entry under HKLM\SYSTEM\CurrentControlSet\Services\Fwsrv\Parameters, configured an protocol definition (without secondary connections) and created the server publishing restricted to an specific client set (just as Q311777 article says to do), but the address translation runs correctly until I reboot the server, after this, the translation stops (the source address that reach the published server is the external address).
Just for information, the client is an server on DMZ created through on three-homed ISA STD Server SP1 FP1 on Windows Server 2003.
I have installed & tested with ISAHF255 and ISAHF257 and the problem continue...
From: Phoenix, AZ
do you get anything in your event log? If you leave it running for a while, does the problem correct itself? I think it might. I've seen couple of times when after reboot some rules dont work and some server publishing dont work, but in alittle while there is an event in event log saying something to this nature: "rule/server publishing applied correctly. this rule has previously failed". So reboot, and let it run for a little be, see if it selfcorrects. I know it should work no matter when, after rebboot or after server restart... just sharing what i know